Application Note: ZMOTION
TM
Detection Module Evaluation Kit
QS007306-0810
2 of 5
Figure 1. ZMOTION
TM
Detection Module Evaluation Kit Components
Setting up for Initial Operation
The simplest mode in which to use the module is “Hardware Mode”. In this mode the sensitivity, ambient light
level and LED ‘On” time are all adjusted using the controls on the Base Board. There are a few simple steps
needed to start using the kit in Hardware Mode:
Step 1: Unpack the hardware components
Step 2: Insert the ZMOTION Detection Module into the Base Board
Step 3: Install the correct AC adapter into the universal supply
Step 4: Ensure the jumpers, switches and potentiometers on the base board are in the correct positions
Step 5: Apply power
Step 6: Demonstrate - Wait about 30 seconds (possibly less), generate motion in front of the module
and look for the blue LED to turn on
