UM023302-1214
13
ZMOTION
®
Intrusion Detection Development Kit
User Manual
Making Changes to the ZMOTION_Intrusion_Demo Project
To change the duration of the LED on time, observe the following procedure.
1. Change the following line in the
main.c
file:
unsigned int cMDDelayTime = DELAY_1SEC;
// LED ON time
2. Change the line as follows to select a five-second LED on time:
unsigned int cMDDelayTime = DELAY_5SEC;
// LED ON time
LED on time
definitions are provided in the
main.h
file for values from 200 ms to 30
minutes.
3. Click the
Rebuild
icon to build the project. The build output should not indicate any
errors. Click the
Go
icon to download the modified project and start the application
running. Generate motion and notice that the LED now stays on for 5 seconds.
4. To change the lens used by the project, edit the
include
line at the top of the
main.c
file to include the appropriate
API_INIT
file. The project initially uses
API_INIT_09.h
to support the ZWA12GI12V4 (board clip-in) lens (see the code
sample below). To use a different lens, edit out the comment characters (//) in the
main.c
file that correspond to the new lens, and comment out the lens that is no longer
in use.
replace with:
// This file must match the lens and PIR sensor used in the application
//#include "API_INIT_00.h"
// Generic settings: non-lens-specific
//#include "API_INIT_01.h"
// API configuration file for AA 0.9 GI V1 Lens
//#include "API_INIT_02.h"
// API configuration file for CM 0.77 GI V3 Lens
//#include "API_INIT_03.h"
// API configuration file for CM 0.77 GI V5 Lens
//#include "API_INIT_04.h"
// API configuration file for CWM 0.5 GI V1 Lens
//#include "API_INIT_05.h"
// API configuration file for NCL-9(26) Lens
//#include "API_INIT_06.h"
// API configuration file for NCL-10IL Lens
//#include "API_INIT_07.h"
// API configuration file for NCL-3B Lens
//#include "API_INIT_08.h"
// API configuration file for NCL-11 Lens
#include "API_INIT_09.h"
// API configuration file for WA1.2 GI 12 V4 Lens
//#include "API_INIT_10.h"
// API configuration file for LR1.2 GI 12 V3 Lens
//#include "API_INIT_11.h"
// API configuration file for VB1.2 GI V1 Lens
The
API_INIT
file must match the lens and pyroelectric sensor being used on the Devel-
opment Board. Use the Lens Selection Guide in the ZMOTION Lens and Pyroelectric
Sensor Product Specification (PS0286) to determine which API_INT file is required for
each lens and Pyroelectric Sensor combination.
Note:
