The Z8 Encore! XP
®
F64XX Series Development Kit
UM028301-0317
8
Z8 Encore! XP
®
F64XX Series Development Kit
User Manual
8. Click
OK
to close the Project Settings dialog box.
9. If you are prompted to rebuild any affected files, click
Yes
. Otherwise, choose
Build
from the menu bar, then click
Rebuild All
.
10. To run the application, select
Go
from the Debug menu. As a result, LEDs D3, D4,
and D5 will blink in sequence.
11. After the application has started, UART0 output should be visible in the terminal
application program, as shown in Figure 5.
HyperTerminal Configuration
A communications program such as HyperTerminal or TeraTerm can be used on Windows
systems to view messages from the F64XX Series Development Board. The following
procedure examines how to configure HyperTerminal for the Z8F64XX demonstration
project.
The HyperTerminal application is not available in Windows 7 systems. If you are using either
of these operating systems, consider using/installing different communication software such as
Tera Term; see
Appendix C. Tera Term Configuration
Figure 5. UART Output Using Terminal Application program
Note:
