UM027202-0816
Establish a Connection with the PC
S3F8S5A Development Kit
User Manual
4
Disconnect or turn off the power to the S3F8S5A Development Board before connecting
or disconnecting the S3 Flash ISP II.
1. Connect the Mini-B side of the USB A (male)-to-Mini-B cable to the S3 Flash ISP II.
Connect the other end of this cable to the PC, as shown in Figure 2.
2. Connect the 10p 5x2 ribbon cable to the S3 Flash ISP II, as shown in Figure 3.
3. Connect the other end of the ribbon cable to Debug Connector J1 on the Development
Board, shown in Figure 4.
Figure 2. Connecting the S3 Flash ISP II to the Development PC
Figure 3. Connecting the 10-pin Ribbon Cable to the S3 Flash ISP II
Caution:
