IWILL DS133R, Manual, Page: 49 / 80

Chapter 4 Hardware Setup
49
DS133R Series
4.8.15 Power On Procedures
1 . After all connections are made, close the system case over.
2 . Be sure that all switches are off.
3 . Connect the power cord into the power supply located on the back of your
system case (please refer to the manual of your power supply).
4 . Connect the power cord into a power outlet that is equipped with a surge
protector.
5 . Many of the power supply support 110V/220V by a switch setting. Switch
your power supply to the correct supply voltage (refer to the power sup
ply’s manual).
6. Turn on your system in the following order:
a. The monitor.
b. The external devices.
c. The computer system.
The power LED on the front panel of the chassis will light. After few seconds,
the system will then run power-on tests. Some additional messages will appear
on the screen during the test. If you do not see anything within 30 seconds from
the time you turn on the power, the system may have failed a power-on test.
Recheck the jumper settings and connections or call your retailer for assistance.
4.8.16 Power Off Procedures
1 . Exit from all the software applications.
2 . Shut down your operating system.
3 . Switch off the power button. If you are using Windows 95/98, the power
supply should turn off automatically after Windows shut down
4 . Turn off all the external devices.
5 . Turn off your monitor.
a. The monitor.
b. The external devices.
c. The computer system.