EN
3-3. Commissioning and operation
Adjust the welding mode to the desired mode (MIG or PMIG) and then adjust other parameters
M
A
V
J O B
A
ME N U
Current, wire feeding speed and thickness of plate:
these three parameters are interacted, that
is if one parameter is changed, the other two will change automatically. In fact, this welding
equipment is equipped with high-intelligent special system, and change to any of this three
parameters will automatically change many detailed parameters according to the database,
which greatly reduces the complexity of operation. Users just need to set the welding mode,
operation mode, material type, diameter of welding wire and current(or wire feeding speed or
thickness of plate), the welding equipment will automatically find out the best parameter combi
-
nation from the expert database. This welding equipment is the most comprehensive, most
authoritative and most intelligent so far.
Arc length:
The expert database specifies the standard arc length (=0), and users can increase
or decrease the arc length based on this value according to the process.
Inductance/ Arc Force: The expert database specifies the standard induction (=0), and users
can increase or decrease the induction/Arc force based on this value. The induction has differ
-
ent influences under different welding modes.
Material typ
e:
users can select corresponding material type in the secondary menu according
to the base metal and material of welding wire.
Diameter of welding wire:
the diameter can be set the secondary menu according the actual
welding wire.
Operating mode:
this can be set in the secondary menu. This welding equipment has five oper
-
ating mode, which is as shown in the following figures:
4T operating mode
2T operating mode
GPR
GPO
t
+
I
I
t
GPO
GPR
+
+
I
I
M anual
Knob for adjusting
the current
Knob for adjusting
the voltage
11
10
