REL0.2
Page 25 of 88
Zynq Ult MPSoC SBC Hardware User Guide
iWave Systems Technologies Pvt. Ltd.
2.5.2
WLAN & BT Module with Antenna connector
The Zynq Ult MPSoC SBC supports
Muruta’s “
LBEE5HY1MW
” based
Wi-Fi & Bluetooth combo module for
connectivity. This module is a very high-performance module based on Cypress CYW43455 combo chipset which
supports WiFi IEEE 802.11a/b/g/n/ac + Bluetooth 5.0 BR/EDR/LE standard. The Zynq Ult MPSoC SBC supports
a 32.768 kHz clock oscillator for this module for sleep operation.
The LBEE5HY1MW Wi-Fi module supports single stream 1x1 IEEE 802.11 a/b/g/n/ac mode providing up to 390Mbps.
The LBEE5HY1MW module features small form factor when integrating Power Amplifier (PA), Low Noise Amplifier
(LNA), Transmit/Receive switch, Power Management. The Zynq Ult MPSoC PS SD1 SDHC controller through
MIO pins are used for Wi-Fi interface which supports 1-bit or 4-bit transfer mode at the clock range of 0-50 MHz and
works at 1.8V IO level.
The LBEE5HY1MW Bluetooth supports Bluetooth 5.0 Basic Rate, Enhanced Rate & BLE. The Zynq Ult MPSoC
PS
’s
UART1 interface thorugh MIO pins is used for Bluetooth interface.
Note: In Zynq Ult MPSoC SBC, SD1 signals from MPSoC is shared with WLAN module and MicroSD connector.
So either WLAN or Micro SD connector can be supported. By default WLAN module is supported in SBC. Contact iWave
to support Micro SD connector.
Note: In Zynq Ult MPSoC SBC, UART1 signals from MPSoC is shared with Bluetooth and Board to Board
connector1 So either Bluetooth or Board to Board connector1 UART can be supported. By default UART1 is supported
in Bluetooth in SBC. Contact iWave to support UART1 on Board to Board Connector1.
Figure 6: WLAN & BT with Antenna Connector
