Hardware User Manual for G8 Q7M i.Mx51 Module
Rev 1.0
Page
22
of
34
iWave Systems Technologies Pvt. Ltd.
4.2 Programming i.MX51 board using Advanced Tool Kit
1.
Connect USB Cable between USB OTG (mini AB, J26) port of Q7 carrier card and PC.
2.
Set the Bootstrap mode in the Processor board as mentioned in picture below (DIP switch
to ON position for bootstrap). Don‟t change the switch setting while power is ON.
3.
After changing the switch position, Power On the system.
Figure 5: Switch Position for Boot Strap Mode
4.
Run the Open Advanced Toolkit application by double clicking the “Advanced Tool Kit
V1.67” located in Desktop.
5.
In Device Setting select the i.MX CPU as iMX51 TO2.
6.
In Device Initial File select the Custom Initial file and Browse the Custom DDR
initialization file “ddr_0to15.txt”.
7.
In Host Setting, select Communication channel as “USB”.
8.
Click Next to Continue
9.
Select Flash Tool and Click Go button.
