Nozzle
In time, the nozzle may wear or be damaged and may need to be replaced.
1. Unscrew the handle.
2. Loosen the needle chucking nut.
3. Gently pull the needle part way back. It doesn’t need to be fully pulled
out.
4. Unscrew the needle cap and the nozzle cap.
5. Unscrew the nozzle counter-clockwise with the provided wrench.
6. Screw the new nozzle into the airbrush body with your fingers.
7. Slightly tighten the nozzle with the provided wrench.
• DO NOT OVER TIGHTEN!
8. Screw the needle cap and nozzle cap onto the airbrush body.
9. Push the needle all the way forward until it seats with the new nozzle.
10. Tighten the needle chucking nut.
11. Screw the handle onto the airbrush body.
TIP: Keep a spare nozzle on hand for unforeseen accidents.
Needle
Needles are subject to easy physical damage because of the long tapered,
extremely fine tip. If the needle point becomes severely bent, it must be
straightened before pulling it back through the nozzle. If not, the bent
needle might damage the nozzle
as it’s pulled through.
TIP: Keep a spare needle on hand for unforeseen accidents.
REPLACEMENT PARTS AND ACCESSORIES
WARRANTY
All Iwata airbrushes are warranted against all manufacturing defects of material and manufacture or workmanship for a period of FIVE years
from date of purchase. This warranty does not cover needles, nozzles, o-rings and internal packings since these parts need to be replaced
occasionally due to normal wear. Any other parts or materials that are or become defective so as not to be usable within this period will be
repaired or replaced. This warranty does not cover damage caused by negligence or airbrushes which have been altered or abused in any way.
Copyright © 2018 ANEST Iwata-Medea, Inc. All rights reserved.
NEOTRIGGER-IM-KMD
