3.
First, connect the RF trigger to a power cord (it’s irrelevant which one, as long as the trigger is
powered). Make sure though, that you can both reach the RF trigger and the power unit of the
lift. If you can’t reach both, you need two persons. (if you don’t have a separate power cord, use
the cord of the projector). If the trigger has power, you will hear a beep.
4.
Now press
[CODE]
on the trigger and hold this button. (You can press these buttons with a pen
or a small screwdriver)
5.
While pressing
[CODE]
, press the small black button on the control unit inside the lift.
6.
The red light on the circuit board will flash shortly and the programming is successful. You can
now release the
[CODE]
button.
1
1
If you have to program your projector, please follow the instructions to program the projector described in the
iVisions_program_RFtrigger_projection screen_ENG manual.
