IVIE MPS 2300, User Manual

Page: 29 / 48

Installation
and Set up
lvie Technologies
MPS 2300
Set-up.
1. Remove the front panel taking care not to
damage the meter wires. (CAUTION: Meter
wires are delicate. Meters are held in by a foam
cushion. Gently snap out of front panel when
removing.)
2. Locate the linking switch next to the left Music
Volume (Zone A) and move to the stereo
position as shown on the label.
3. Limit the knob travel of the selector (Zone A) to
Off, 1 and 2. (See Music Source Selector Knob
Rotation Limit above, for procedure)
4. Replace the front panel and knobs.
5. Zone B Source Selector is now defeated.
Remove knob and replace with lock-out plug.
6. Music Source input channels 1 & 2 become “left
and right” for position 1 on the Source Selector
while inputs 3 & 4 are actuated on position two.
Use rear panel Gain and EQ to balance Left
and Right Inputs 1 & 2 and 3 & 4.
7. Wire the mic key to both zones if paging is
desired on both “right and left” channels.
Operation.
Stereo Remote Hook-
up.
1. Two stereo sources may be selected using the
first two positions of the Zone A Music Source
Assignment Selector.
2. The volume controls work independently.
Changing the level is accomplished by turning
both controls. Alter balance by adjusting each
control separately.
Same as 2-zone with these exceptions:
1. Parallel wire the Music Fader terminals for both
zones to the Remote Fader pot.
2. Reset Music Fader trimmer on lvie Remote so
that 5K ohm is measured across the fader with
Fader fully clockwise.
3. Same for Page Volume.
4. Wire Source Selector to Zone A remote
terminals only. Lock out positions 3 and 4,
using the procedure shown in Music Source
Selector Knob Rotation Limit, above. Change
0 from 4.3K to 2.2K