and the lift motion control event will be automatically enable.
(With vehicle stationary and during the lift-
ing cycle diagnostic display on some vehicles might show “ No power to lift motor” or audio signal might
be activated for short time period.)
Consult vehicle wiring diagram or contact the
OEM for the proper interface of two black
wires to control lift pump motor travel
Method B.
(Some electric pallet trucks with stand alone pump solenoid)
Use two
Black wires and splice them in series with one of the lift solenoid coil wires activating the
lift motor.
Disconnect one of the original solenoid coil wire
( From either positive or negative terminal of the
solenoid coil)
and splice two BLACK wires in series
to
disconnected wire of the either solenoid terminal.
!
!
The predetermined motion of the lifting cylinder and the load weight measurement “weighing cycle” will be
initiated and controlled automatically by the software algorithm based on the input from the pressure trans-
ducer signal. Once the load weight is shown on the LED display internal relay will be de-activated and the lift
motion control event will be automatically enable.
(With vehicle stationary and during the lifting cycle diag-
nostic display on some vehicles might show “ No power to lift motor” or audio signal might be activated
for short time period)
Note:
When unloaded vehicle is in motion the hydraulic “spikes from pressure transducer signal” might
be seen by the vehicle controller as start of the “weighing cycle”. Short interruption of the power to the
lift solenoid coil on “
some controllers”
is
seen as a “fault” and power to the vehicle will be cut.
Solution:
- When moving unloaded vehicle turn ED2-EP indicator power switch
to OFF POSITION.
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
