operation
It is recommended to clean the unit before first use. Additionally, for the appliance’s longevity, it is suggested to wait a few
minutes after moving the icemaker around before starting the ice-making process.
1. Plug Power Cord (14) into wall outlet with proper voltage ratings.
2. Open Hinged Cover (7) and remove Ice Storage Box (10).
3. Pour in clean drinking water through until it reaches Water Level Max (11).
4. Select your ice cube size by pressing the corresponding button.
5. Press the Start/Standby Button (1) to initiate the process.
Note: One ice-making cycle lasts approximately 6 to 13 minutes, depending on selection of ice cube size and room
temperature. Recommended room temperature is 50°F to 110°F. If room temperature is below 59°F, it is recommended
to select the smaller ice cube size in order to avoid the cubes sticking together.
When the Water Low Indicator (4) goes on, pour more water into the unit. If an icemaking session is in process, pause it first
by pressing the Start/Standby Button (1). Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting. Then press the Start/Standby Button (1) to resume.
When the Ice Box Full Indicator (5) goes on, the ice-making process will automatically pause, allowing you to remove ready
ice cubes. Press the Start/Standby Button (1) to resume.
Note: Direct sunlight may cause infrared sensor malfunction. If unit doesn’t stop even when ice cubes obstruct sensors,
move away from sunlight. To maintain hygiene level, change water in unit every 24 hours.
care & maintenance
- Unplug appliance before cleaning.
- Use clean cloth to clean both the appliance’s interior and exterior.
- To clean the internal water tank:
• Open Hinged Cover (7) and remove Ice Storage Box (10).
• Remove cap covering Water Drain (15).
• Allow any excess water to drain from tank, then retighten cap.
• Pour clean water into unit, then use clean cloth to swish the water around and clean inside of unit.
• Unscrew cap again and allow water to drain.
• Repeat steps until water drain fully clean.
- Do not use organic solvents, boiling water, cleaning agents, strong acids, or alkali.
- If icemaker will not be used for a prolonged period of time, unplug power cord, drain water from unit, dry appliance with
a clean cloth, and store unit in a clean, dry place.
specifications
Dimension:
9.5 x 14.1 x 12.9 in
Ice making capacity:
26.5 lbs./24hrs
2 ice cube sizes:
small, large
Internal storage:
1.5 lbs.
Ice Scoop:
1pc included
Time required:
6−13 minutes
Water tank capacity:
2.5 quarts
Rated power input:
110 W
Rated freqzuency:
60Hz
Voltage:
110-120V
Refrigerant:
R134a
Distributed by
C & A Marketing
2 Bergen Turnpike
Ridgefield Park, NJ 07660
Made in China
ivation is a trademark of
C&A IP Holdings, LLC
©2014 All right reserved
