Problem
Vacuum will not operate
Dust is coming from the motor cover
The motor is overly loud
Possible causes
Lack of power
Faulty power cord
Tank is full
The cartridge filter or paper dust
collection bag is missing or damaged
There is a blockage in the hose or the
tank inlet.
The cartridge filter or paper dust
collection bag is blocked.
Solution
Check power supply (cord, breakers, fuses, etc.)
Unplug and check the power cord. If damaged,
have it repaired by a professional
Empty tank
Attach or replace cartridge filter or paper
dust collection bag
Check the nozzle, hose, and tank inlets
for blockage.
Clean the filter or install a new filter or
paper dust collection bag
Operation
Powering the unit on
1. To power on, switch to the “I” position
2. To power off, switch to the “0” position
Dry vacuuming
1. Install the cartridge filter and paper dust collection bag before dry vacuuming.
2. Check that filters are securely in place before vacuuming.
Wet vacuuming
1. Install the foam filter before wet vacuuming.
2. Check that the filter is securely in place before vacuuming.
Draining water after wet vacuuming
1. Open the water drain screw by turning it counterclockwise.
2. Drain the liquid.
Note: when wet vacuuming, the floating safety switch will close when the maximum tank level is reached. This will result in the unit
becoming louder. When this happens, switch off the unit and empty the tank.
Setting up the blower
1. Before switching the hose from suction to blowing, unplug the unit.
2. Empty the unit of any dirt or liquid before using the blower.
3. Remove the hose from the vacuum port.
4. Connect the suction hose to the blow connector on the backside of the power head, locking it into position.
5. Fit the hose with the desired extension and/or nozzle.
6. Plug the unit into the power supply.
7. Before turning the vacuum on, firmly hold the loose end of the hose. Turn the switch to the on position.
Care and maintenance
Cleaning the appliance head
• Clean regularly with a damp cloth and mild detergent. Do not use cleaning agents or solvents, as these may damage the plastic
parts in the unit.
Cleaning the tank
• Clean regularly with a damp cloth and mild detergent. If the level of dirt is low, clean with running water.
Cleaning the foam filter
• Clean the filter with a small amount of mild detergent under running water. Allow to air-dry.
Cleaning the cartridge filter
• Block the hose inlet, then press the push and clean button. This will quickly blast the dirt from the cartridge filter.
Troubleshooting
5
