background image

Digital Gun Safe

USER GUIDE

IVAQA8X10SF

Thank you for purchasing the Ivation Digital Gun Safe. This User Guide is intended to provide you with 
guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that 
does not conform to the guidelines described in this User Guide may void the limited warranty. 

Please read all the directions before using the product and retain this guide for reference. This product is 
intended for household use only. 

This product is covered by a limited one year warranty. Coverage is subject to limits and exclusions. See 
warranty for details. 

Box Contents

Shelf-mountable safe 
2 emergency keys 
4 AA batteries 
Mounting hardware 
User guide

Parts

1. Key lock 
2. Combination buttons 
3. Reset button (inside safe) 
4. Battery compartment

Required Tools 

Drill 3/16” drill bit 
Flat head screwdriver 
10 mm wrench

IMPORTANT:

 

• Please write down your combination and the safe’s serial number and store them in a secure spot that 

you will remember. 

• Keep keys and combination in a secure place away from children. 
• DO NOT STORE YOUR KEYS OR COMBINATION INSIDE THE SAFE.

Summary of Contents for IVAQA8X10SF

Page 1: ...ntended for household use only This product is covered by a limited one year warranty Coverage is subject to limits and exclusions See warranty for details Box Contents Shelf mountable safe 2 emergency keys 4 AA batteries Mounting hardware User guide Parts 1 Key lock 2 Combination buttons 3 Reset button inside safe 4 Battery compartment Required Tools Drill 3 16 drill bit Flat head screwdriver 10 ...

Page 2: ... the battery compartment is open install 4 AA alkaline batteries as shown 4 Click cover back into place by inserting the rear tabs into the appropriate slots 5 Do not mix old and new batteries 6 Do not mix alkaline standard and rechargeable batteries Note If the batteries are low the combination buttons will flash red when they are pushed Please replace batteries as soon as possible if lights flas...

Page 3: ... s no need to press it again for the second and last confirmation Opening the Safe Using Your Combination 1 Enter your combination 2 The buttons will light up green and there will be one beep if the sound is turned on after each part of the combination is entered Note You will have 10 seconds between each button push before the safe assumes you have entered the complete combination 3 If you enter ...

Page 4: ...her side of the drawer s track and pulling the drawer out of place 2 Place the safe in the desired location on a shelf and mark the location of the pre drilled mounting holes on the bottom of the safe with a pencil 3 Remove the safe from the shelf where you will be securing it 4 Drill pilot holes for the screws make sure they are 3 16 in diameter 5 Place the safe back on the shelf and line up the ...

Reviews: