Ver. 2011-10
www.metsjo.se
19
9
4
3
4
Slack adjusters
– every 500 hours in operation, at least
once a year –
Lubricate the grease nipples with BPW
special longlife grease (ECO�Li 91), until
fresh grease emerges.
5
Automatic slack adjuster
ECO-Master
– each time the brake shoes are replaced –
– every 500 hours in operation, at least
once a year –
Remove the rubber cap.
Lubricate with BPW special longlife grease
(ECO�Li 91) (80 g) until sufficient clean
grease emerges from the adjusting bolt.
Undo the adjusting bolt by approximately
one turn with a ring spanner. Operate the
brake lever by hand several times.
In doing so, the automatic adjustment
must operate smoothly.
Repeat several times, if necessary.
Refit the cap.
Regrease with BPW special longlife
grease (ECO�Li 91).
English
8
1
2
2
3
Note: All the lubrication points should
be re-lubricated with grease after the
vehicle has been cleaned with a high-
pressure washer.
1
Top and bottom steering pivot bearings
– every 40 hours in operation –
Lubricate via the grease nipples with
BPW special longlife grease (ECO�Li 91),
until clean grease emerges from the
bearing/cam plate.
2
Locking cylinder ends on steering axles
– every 200 hours in operation –
Lubricate via the grease nipples with BPW
special longlife grease (ECO�Li 91), until
clean grease emerges from the bearings.
While carrying out this lubrication, ensure
that the locking cylinder and the pipe
contain no air at any time.
3
Outer and inner brake camshaft bearings
– every 200 hours in operation –
(and before use after a long period of
inactivity)
Lubricate via the grease nipples with BPW
special longlife grease (BPW ECO�Li 91),
until clean grease emerges from the
bearings.
Caution. Do not allow grease or oil to get
into the brake. Depending on the series,
the cam bearings to the brake may not be
sealed.
Use only lithium�based grease with a drop
point above 190 °C.
BPW trailer axles
