Receiver
1.
Connect the DC POWER ADAPTER to the receiver’s DC INPUT
then plug the other end of DC POWER ADAPTER into the WALL
OUTLET
2.
Connect one end of ¼ “ to ¼ “ cable to receiver’s UNBALANCE
AUDIO OUTPUT (MIX) and the other end to a mixer. If you are
using the BALANCE AUDIO OUTPUT, use a XLR to XLR cable or
XLR to ¼ “ cable
3.
Install the antenna into each antenna socket on rear panel, then
fasten the antenna towards the right side till the antenna is
vertical with ground
4.
Push/Open the microphones handle/bodypack cover to check
to see if there are batteries. If not, install the batteries into the
microphones with the negative and positive end of the battery
correspond the negative and positive end of the microphone.
Push/Close the microphone handle/bodypack back on
Parameter
Receiver
Oscillation Mode
Quartz Controlled Fixed Frequency
Carrier Wave Stability
10 PPM
Sensitivity
-105dB @ sinad=12 dB
S/N Ratio
>105dB
T.H.D
<0.5% @1 kHz
Image Rejection
85 dB typical
Spurious Rejection
75 dB typical
Frequency Responses
40Hz – 18kHz
Working Distance
30 meters at empty space
Squelch Control
Dual Squelch Circuit
AF Output Impedance
2.2 kohm
Max Output Level
Balance: 0-400mv, Unbalance: 0-200mv
Display
LED
Power Supply
External DC Power Supply, 0.35A, 12-18V DC
Output Connector
2 x XLR Balanced Socket, Unbalanced TRS
Dimension (mm)
420 (W) x 45 (H) x 195 (D)
Weight (KG)
2.1
Transmitter
Transmitter Power
30mW
Spurious Emission
<40dB (with carrier)
Display
LED
Battery Voltage
1.5V x 2
Battery Life
5 hours depends on usage
Frequency Response