ITW LOVESHAW LITTLE DAVID LD7D/M, Owner'S Manual

Page: 7 / 57

LOVESHAW an ITW Company
INSTALLATION
THE LITTLE DAVID IS SHIPPED COMPLETELY ASSEMBLED.
THE LITTLE DAVID IS READY FOR OPERATION AFTER PLUGGING IT INTO AN APPROPRIATE
GROUNDED ELECTRICAL OUTLET. THE CONNECTION CABLE IS LOCATED ON THE REAR OF THE MACHINE.
THE HEIGHT OF THE MACHINE CAN BE ADJUSTED FROM 22 INCHES TO 30 INCHES (559 mm to 762 mm)
IN ONE INCH INCREMENTS BY ADJUSTING THE HEIGHT OF THE LEG EXTENSIONS.
DUE TO ITS PORTABILITY AND EASY PLUG-IN CONNECTION, THE MACHINE MAY BE QUICKLY MOVED TO
VARIOUS LOCATIONS AS THE NEED ARISES.
AN OPTIONAL INFEED TABLE CAN BE INSTALLED AT THE INFEED END OF THE MACHINE, HOWEVER,
A CONVEYOR MAY BE USED INSTEAD. THE INFEED TABLE CAN BE USED SO THAT THE PACKER CAN FILL
THE BOXES AND CLOSE THE FLAPS PRIOR TO FEEDING THE BOXES IN THE MACHINE. A CONVEYOR
SHOULD BE PROVIDED AT THE OUT FEED END OF THE MACHINE TO RECEIVE THE BOXES AS THEY ARE
DISCHARGED FROM THE MACHINE.
IMPORTANT: BE SURE THE TABLE AND CONVEYOR ARE 1/4” (6 mm)
BELOW THE MACHINE BELT HEIGHT.
MACHINE BOLTING PROCEDURE:
THE LD7E MUST BE FASTENED TO THE FLOOR TO AVOID TIPPING WHEN THE HEAD IS IN THE HIGHEST
“UP” POSITION. THERE ARE HOLES LOCATED ON THE BOTTOM OF EACH OF THE LEG EXTENSIONS FOR
FASTENING THE MACHINE TO THE FLOOR. THE MACHINE SHOULD BE LEVEL AND SHOULD NOT ROCK.
TO FASTEN THE MACHINE TO THE FLOOR, USE SPECIFIED HARDWARE LISTED BELOW.
CONCRETE FLOOR: - WEDGE STUD ANCHOR
1/2 INCH DIA. ANCHOR MIN. EMBEDMENT DEPTH = 2 1/4” GRADE 5 STEEL.
INSTALLED TO MANUFACTURER’S SPECIFICATION.
WOOD AND OTHER FLOORING:
1/2 INCH DIA. LAG SCREW MIN. EMBEDMENT DEPTH = 3” GRADE 2 STEEL.
INSTALLED TO MANUFACTURER’S SPECIFICATION.