REPAIR INSTRUCTIONS
Refer to pages 10 & 11 of this manual for additional part information and location.
GRIPPER AND WEAR PAD DISASSEMBLY
Remove the following parts:
•
Front roll pin (38)
•
•
Front link (25)
•
Gripper (24)
•
Roll pin (15)
•
Wear pad assembly (37)
Clean, inspect and replace worn and/or broken parts. Clean gripper with wire brush.
NOTE: Gripper can be re-used by rotating it to a new position on the hexagonal gripper shaft.
GRIPPER AND WEAR PAD REASSEMBLY
Clean, inspect and replace worn and/or broken parts before reassembly. Lubricate all moving
parts with Mo-Lith #2 grease, or equivalent, before reassembly. Install the following parts as
described:
•
Wear pad assembly (37)
•
Roll pin (15)
•
Gripper (24) - Rotate gripper so that unworn teeth contact the strap.
•
Front link (25) - Grasp the support pin (29) with pliers at rear link (26) and rotate to align
hole.
•
Front roll pin (38) - Drive in roll pin. Check that pawl handle is spring loaded in both
directions.
For Parts & Service 1-877-862-6699
WWW.TRADITIONALTOOL.COM
