TROUBLE SHOOTING
The [Replace Filter] indicator
keeps flashing.
It is reminding you to replace your filter. The indicator will keep flashing unless it is
replaced.
After replacing the filter, press on [Replace Filter button] for 3 seconds to reset the
purifier and quench the indicator.
No wind comes out of the air
outlet.
The adapter is not connected to the purifier. Please plug the adapter to it.
Make sure the filter is mounted correctly.
Make sure the bottom cover is aligned to the marker line.
The air is too humid to be purified.
The air inlet or outlet is obstructed.
The area is larger than 10m³. Its applicable area is 8.4m³.
Air quality does not change
even though the purifier has
run for a long time.
Dusts in the air cause stains
that are hard to remove.
Check if the filter is dirty and replace it.
Make sure the packaging film of the filter is dismantled.
Check if the filter is dirty and decide whether to replace it.
Too much noise.
TROUBLE SHOOTING
If a problem occurs, please try the following solutions before calling our customer service team.
PRECAUTIONS FOR MAINTENANCE
1. Make sure to unplug the adapter and disconnect it from power supply before maintenance.
2. Wipe the product and operation panel with a dry, soft cloth.
3. Please use only neutral detergent. Do not use abrasive powder, alkaline detergent, bleach, alcohol or gasoline to
clean the product.
4. Do not use a hard cloth to wipe the product. Or it will cause damages to the surface.
5. Do not use a wet cloth to wipe its cord. Or residual water may cause electric shock.
1. The filter shall not be washed with water;
2. It is recommended to change the filter in time after reaching its service life;
3. Please wipe the body part with a wet, soft cloth.
4. Do not use water or corrosive detergent to clean the body part;
5. Use a small, soft brush to clean the upper air outlet;
6. After cleaning, restore its components and connect it to the power supply for a normal use.
CAUTIONS FOR CLEANING
1.Gently press on the [ON/OFF button] until the indicator quenches to power off the product.
Then open the turn-knob to take off the bottom cover and pull out two filters.
2. Remove the packaging film of new filters.
3. Replace the old ones and remount the bottom cover.
4. Press on [Replace Filter button] for more than 5 seconds, until the red indicator blinks 6 times (twice per second)
to complete the reset process.
REPLACING THE FILTER
1. Der Ersatzzyklus des Filterelements beträgt 3-6 Monate. Wenn es festgestellt wird, dass das Filterelement ersetzt
werden muss, flackert der FILTER RESET. Das neue Filterelement muss rechtzeitig ersetzt werden.
2. Das Filterelement darf nicht mit Wasser in Berührung kommen oder beschädigt werden.
3. Bitte behandeln Sie das gebrauchte Filterelement als brennbaren
PRECAUTIONS
Make sure the product is not used in a space filled with strong smells for a long time,
weeks or months (for example, cigarettes, barbecues and other strong smells).
The purified air smells.
MAINTENANCE
09
10
