Introduction and Safety
i-ALERT®2 Equipment Health Monitor Installation, Operation, and Maintenance Manual
6
(EN 61000-4-3:2002 per EN 61000-6-2:2007 +AMD 1 Cor 12)
(EN 61000-4-3:2006+A1:2008+A2:2010 per ETSI EN 301 489-1 V1.9.2
Power Frequency Magnetic Field Immunity Test
(EN 61000-4-8 1993 per EN 61000-6-2:2007 +AMD 1 Cor 12)
Standards for testing Bluetooth radio
Industry Canada, Interference-Causing Equipment Standard for Information Technology
Equipment (ITE)
ICES-003 Issue 5 August 2012
Electromagnetic compatibility (EMC). Generic standards. Immunity for industrial environments
CENELEC EN 61000-6-2:2007 +AMD 1 Cor 12
Electromagnetic compatibility (EMC) Generic standards - Emission standard for industrial
environments
CENELEC EN 61000-6-4:2007
Electromagnetic Compatibility (EMC) standard for radio equipment and services;
Part 1: Common technical requirements
ETSI EN 301 489-1 V1.9.2 (2011-09)
ElectroMagnetic Compatibility (EMC) standard for radio equipment;
Part 17: Specific conditions for Broadband Data Transmission Systems
ETSI EN 301 489-17 V2.2.1 (2012-09)
FCC Regulatory Information
The FCC identifier for the radio module contained in the i-ALERT
®
2 device is FCC ID:
T7VPAN17.
The radio module in the i-ALERT
®
2 device meets the requirements for modular transmitter
approval as detailed in FCC public Notice DA00-1407. Transmitter Operation is subject to the
following two conditions:
1. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by ITT may void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help
RF Exposure
To comply with FCC RF Exposure requirements, do not modify, remove or change the antenna
on the radio module contained within the i-ALERT
®
2 device.
The radiated output power of the radio with mounted ceramic antenna (FCC ID: T7VPAN17) is
far below the FCC radio frequency exposure limits. Nevertheless, the radio shall be used in
such a manner that the potential for human contact during normal operation is minimized.