U.S.A.
Jabsco
20 Icon,
Foothill Ranch, CA 92610-3000
Tel: (949) 609.5106
Fax: (949) 859.1254
UNITED KINGDOM
Jabsco
Bingley Road, Hoddesdon
Hertfordsire EN11 OBU
Tel:
+44 (0) 1992 450145
Fax: +44 (0) 1992 467132
CANADA
Fluid Products Canada
55 Royal Road
Guelph, Ontario N1H 1T1
Tel:
(519) 821.1900
Fax: (519) 821.2569
JAPAN
NHK Jabsco Company Ltd.
3-21-10, Shin-Yokohama
Kohoku-Ku, Yokohama, 222
Tel:
045.475.8906
Fax: 045.475.8908
GERMANY
Jabsco GmbH
Oststrasse 28
22840 Norderstedt
Tel:
+49-40-53 43 73 -0
Fax: +49-40-53 53 73 -11
THE PRODUCT DESCRIBED HEREIN IS SUBJECT TO THE JAB-
SCO ONE YEAR LIMITED WARRANTY, WHICH IS AVAILABLE FOR
YOUR INSPECTION UPON REQUEST.
© Copyright 2003, ITT Industries Printed in U.S.A.
All Rights Reserved
Form: 43000-0369
Rev. 4/2003
DISASSEMBLY INSTRUCTIONS
1.
Remove end cover screws, end cover and gasket.
2.
Remove drain plug from body. Insert Allen wrench
through priming hole to loosen impeller set screw.
Withdraw impeller from shaft and body.
3.
Remove two motor mounting screws. Remove body
from motor.
4.
Press seal out of body towards motor flange end.
Check motor shaft for wear in seal lip area. Replace
motor if shaft is deeply grooved. This will only
happen, normally, if pump is run dry for extended
periods.
ASSEMBLY INSTRUCTIONS
1.
Support body on front face (impeller end). Lubricate
OD of seal and press into seal bore with lip facing
toward impeller until it bottoms firmly against
shoulder. Center seal retainer (concave side up)
in seal cavity and press firmly against seal using
11/16" dia. dowel.
2.
Position slinger on shaft 1/8" from motor face.
3.
Lubricate inside diameter of seal and shaft with
water pump grease. Install body to motor and secure
with two screws.
4.
Start set screw into impeller boss. Push impeller on
shaft with set screw centered on shaft flat, until
impeller contacts rear face of body. Pull impeller
away from body 1/32" and tighten set screw by
inserting Allen wrench through priming hole in body.
Turn impeller to make sure there is no metal contact.
5.
Install gasket, end cover and secure with four end
cover screws and lock washers.
6.
Install priming plug in body with a light coat of
sealant.
PARTS LIST
Kit
Description
Kit Number
Screw End Cover
A
Lock Washer
18514-1000
End Cover
Gasket
B
Impeller
18515-2000
Set Screw - Impeller
Kit
Description
Kit Number
Seal
D
Screw - Motor Mtg. (3/kit)
1040-4101
Slinger
E
Body - Volute
18513-5000
Plug
F
Motor - ENV 115/1/60
18735-0082
EXPLODED VIEW
REPLACEMENT PART KITS
JABSCO RECOMMENDS THAT ALL COMPONENTS IN
EACH INDIVIDUAL KIT BE REPLACED AS A MATTER OF
GENERAL MAINTENANCE.
A
- Plate Kit
B
- Impeller Kit
D
- Seal Kit
E
- Body Kit
F
- Motor Kit
