6
6.2. Load a configuration stored in a USB memory stick into the AP8 programable
amplifier
This process can be used to clone the same configuration to several AP8 programmable amplifiers.
1.
Make the connections between the antenna and power feeding.
2.
Connect physically the programmer and the AP8 programmable amplifier by using USB cable
3.
Connect to the programmable amplifier (CONNECT
LOAD). The front PR PRO LED will switch on.
4.
Access to the USB memory stick, specifically to the configuration menu: PENDR
CONFIG
LOAD.
5.
Select the desired file (in case there is more than one) and confirm.
6.
After this moment, slight adjustments may be done to the amplifier or just disconnect.
6.3. Load a configuration of the AP8 programable amplifier into the PR PRO
programmer from a USB memory stick and edit it (Without being connected into a AP8
programmable amplifier).
Note: In the USB memory stick there has first to be two files. A menu structure and a configuration file (AP8_Mxxx.xml and
AP8_Cxxx.xml)
1.
Connect the PR PRO to a +9Vdc voltage power supply.
2.
Load from the USB memory stick to the PR PRO a menu file: PENDRV
MENU
LOAD. AT this moment, the
programmable amplifier can pretend being an AP8 programmable amplifier.
3.
Load to the PR PRO the file that contains the configuration of the amplifier that has to be modified: PENDRV
CONFIG
LOAD.
4.
Select the file (in case there are more of this kind) and confirm.
5.
Seleccionar el fichero (en caso que haya más) y confirmar.
6.
Go back to the main menu and enter into the amplifier (AP 8). At this moment it is possible to edit the loaded
parameters.
7.
Once edited, it is possible to store the new configuration to the USB memory stick: PENDRV
CONFIG
SAVE.
7. Technical characteristics
REFERENE
PR
PRO
CÓDE
072003
Connectors
USB-A,
USB-MiniB, RJ45, DC Jack
USB system files
FAT 32
Buttons
5
Compatible devices
AP 8
Voltage feeding
Vdc
5 (Via USB)
9 (Via DC JACK)
Consumption
300mA @ 9V (Sin USB)
Dimensions
cm
10,7 x 67,4 x 19,5
Weight Kg
0,2
