-3-
PREPARATION FOR USE
ALARM CLOCK OPERATION
Setting the time
• When the clock display is blinking, you cannot power on radio by the
/ OFF / NAP” button (2).
“ON
This clock radio includes a battery backup system that will maintain the time
and alarm settings during a temporary power interruption. Insert two 'AAA'
size batteries (not included) correctly by matching the polarity (+/-) markings
in the battery compartment (10). If you experience a power failure while
batteries are installed, the display will turn 'off' but the clock will continue to
run and maintain your alarm settings. When replacing batteries, please
replace all batteries at the same time with only new batteries.
The clock radio has slip proof silicon feet. Place the clock radio only on
protected furniture.
Unwind the FM antenna (11) on the back of the clock radio. Extend and
reposition the antenna for best radio reception.
1 Press and hold down “TIME / PRESET” button (6) for approximately 3 seconds
until the display flashes.
.
2
.
Press “HOUR / TUNING –“button (5) repeatedly to change the hour setting.
3 Press “MIN / “button (9) repeatedly to change the minute setting.
.
4 Press “TIME / PRESET” button (6) to confirm the time and the display will stop
flashing.
.
SETTING THE ALARM TIME
This clock radio has dual alarms that can be set and used independently.
The procedure to set both alarms are the same. Both alarms can either
sound the buzzer or radio.
-4-
•
the “ON / OFF / NAP” button (2) to turn FM radio or AM radio on. Press and
hold down the “ON / OFF / NAP to turn the radio off.
Note: The alarm time can only be set when the radio is turned off. Press
1. For setting alarm time 1 with buzzer, press “ALARM 1 / VOL –“ button (4) and
indicator (E) will flash. For setting alarm time 1 with radio, press “ALARM
1 / VOL –“ button (4) twice and indicator (F) will flash.
2. When the digits are flashing, press “HOUR / TUNING –“ button (5) repeatedly
to change the hour setting. Press “MIN / “ button (9) repeatedly
to change the minute setting.
TECHNICAL SPECIFICATIONS
•
–
FM Frequency: 87.5 108MHZ
•
–
AM Frequency: 522 1620KHZ
• ADAPTER Model: GPU410501000WD00
• ADAPTER input: 120VAC 60HZ
• ADAPTER output: 5.0VDC 1.0A
• Supplier of adapter: Huxu Electronics Factory
• The time can only be set when the radio is turned off. Press the “ON / OFF
/ NAP” button (2) to turn the FM radio or AM radio on. Press and hold down
the “ON / OFF / NAP to turn the radio off.
• You cannot set any function when the clock display is blinking after
plugging the device in, press the “TIME/PRESET” to stop the blinking
and
begin to set the settings.
Note:
5. When the alarm sounds, press any button to turn off alarm or press “SNOOZE
/ SLEEP / DIM” button (1) to enter snooze mode. or
blink during
will
4. To cancel the alarm, press “ALARM 1 / VOL –“ button (4) three times when
the current time is showing. The alarm indicators will turn off.
3. Press “ALARM 1 / VOL –“ button (4) to confirm.