
www.itrackgpstrackers.com
12
6.21.5.2.
Set up: When the unit stays immobile in a place for 3-10 minutes, the user can send SMS
“spspace+latitud
e,long
itude;latitude,longitude”to unit to set the restricted
area. In the
event of a breach, it will send the
SMS “st latitude & longitude” to the
authorised numbers.
Attention: The first latitude & longitude is coordinate of the top left corner of the Geo-fence, while the
second latitude & longitude is the coordinate of the bottom right corner. It will send SMS alarms at 3
minute intervals once the tracker breaches the boundary.
6.21.5.3.
To cancel:
Send SMS “nospassword” to deactivate this functio
n.
6.20.6.
Multi-area management
6.21.6.1.
Set area
Send the SMS command: area+pspace+latitude,lospace+areaname,distanceM" to GPS
tracker (distance unit: M for meter, K for kilometer), it will reply "area01 ok".
For Example: Send: "area123456 22.353648,113.543678 school,800M".
Note: 5 areas maximum. Distance between two points can't be less than the total distance in the 2 commands,
and different areas can't cover each other.
6.21.6.2.
Delete area
Send the SMS command:
"pspace+area name” to
the tracker and it will reply: "noarea ok".
6.21.6.3.
Rename and set distance
Send the SMS command "pspace+old name;new name,distanceM" to the tracker. If the
name is not repeated and the area doesn't cover others it will reply "rename ok!" for successful configuration.
Example: Send "rename123456 area01;school,800M" - this means the new area name is "school" and it covers
an area of a radius of 800 meters.
6.21.6.4.
Activate multi-area management
Send the SMS command "area+pspace+on" to the tracker and it will reply "Area on ok!". When the
tracker enters the pre-set area, the tracker will send the SMS "area name+latitude & longitude" to all the
authorised phone numbers and send the same SMS when goes out of the area.
6.21.6.5.
Deactivate Multi-area management
Send SMS command "area+pspace+off" to the tracker and it will reply "area off ok!
6.20.7.
Movement alarm
6.21.7.1.
Set up: when the unit stays immobile in the same place for 3-10 minutes with an active GPS signal, the
user can send the SMS command
“move+pspace+0200” t
o the tracker (This example is a radius
of 200 meters - it supports 4 digits at most. Units: Meters). It will r
eply “move OK”.
In the case of such
a movement it will send the
SMS “Move
+ latitude & longitude” to the
authorised numbers. (the default
distance is 200m)
6.21.7.2.
To cancel: Send SMS
“password” to deactivate the move
ment alarm.
6.20.8.
Over speed alarm
6.21.8.1.
Set up:
Send SMS “speed+pspace+080” to the unit (
This example uses a speed of 80km/h), and
it will reply “speed OK!”. When the target m
oves and exceeds 80km/h, the unit will send the SMS
“speed+080!+ latitude & longitude” to the
authorised numbers. It will send only one SMS in 3 minutes in
SMS mode.