Itm Holemaker HMP45, Operator'S Manual

Page: 10 / 34

®
HMP45 OPERATOR’S MANUAL
10 www.holemaker.com
2.4 Before first use:
• Steel elements of the drilling machine are protected for transit and storing with grease film.
• Before first start up of the machine all grease should be removed before each use all
handles should be screwed into pinion.
2.5 Before you cut
Control elements include:
• MAGNET
switch,
• MOTOR switch.
To start the machine, follow these steps:
• Make sure that both the motor and magnet ON/OFF switch are in the OFF position.
• Plug machine into air supply, and position drill
• Slide the magnet ON/OFF switch to the ON position.
• Toggle the motor switch to ON position, after pulling back the safety latch of the switch.
• Once cut has been completed, toggle the motor ON/OFF switch to the off position.
• To position the machine in a new drilling spot, the magnetic base switch has to be toggled
to OFF position.
READ THE WHOLE INSTRUCTIONS MANUAL BEFORE ATTEMPTING TO START UP
2.6 Before you cut
• Before positioning the machine on work piece always make sure that:
• Work piece is made of ferrous steel (some grades of stainless or acid resistant steel
do not conduct magnetic flux)
ON
MAGNET
OFF
OFF
ON
MOTOR