EN
Monitoring Software Installation (For Windows OS)
1. Insert the included installation CD into CD-ROM or go to
the website
http://www.power-software-download.com
drive and then follow the
on-screen instructions. If there no screen shows when inserting the CD after 1 minute,
please execute setup.exe for initiating installation software.
2. Follow the on-screen instructions to install the software.
3. When your computer restarts, the monitoring software will appear as an orange plug
icon located in the system tray, near the clock.
Trouble Shooting
Problem
Possible Cause
Solutions
No LED display on the
front panel.
Low battery.
Charge the UPS at least 6 hours.
Battery fault.
Replace the battery with the same type of
battery.
The UPS is not turned on.
Press the power switch again to turn on
the UPS.
Alarm continuously
sounds when the
mains is normal.
The UPS is overload.
Remove some loads first. Before
reconnecting equipment, please verify
that the load matches the UPS capability
specified in the specs.
When power fails,
back-up time is shorten.
The UPS is overload.
Remove some critical load.
Battery voltage is too low.
Charge the UPS at least 6 hours.
Battery defect. It might be
due to high temperature
operation environment, or
improper operation to battery.
Replace the battery with the same type of
battery.
The mains is normal
Bu the unit is on
battery mode.
Power cord is loose.
Reconnect the power cord properly.
