Itec AV-BOX, Instruction Manual, Page: 9 / 12

ITEC AV-BOX
www.itec-audio.com
9
AV-BOX
14. Changing batteries of radio microphones (AKG)
Attention: old batteries are hazardous waste; dispose of properly!
1. Depress the snap hook on the battery compartment lid.
2. Pull the battery compartment lid down to remove it from the transmitter.
The foam pads on the inside of the battery compartment lid holds the batteries in place. Do not remove the
foam pad. If you do, the batteries will not be held in place properly and may cause rattling noise.
3. Insert the supplied batteries into the battery compartment conforming to the polarity marks.
The transmitter will not function with incorrectly inserted batteries.
4. Set the on/off switch to “ON” to switch the power to the transmitter on.
The status LED will fl ash momentarily.
If the batteries are in good condition, the status LED will extinguish.
If the status LED illuminates the batteries will be dead within about 50 minutes: Replace the batteries with new
ones as soon as possible.
If status LED fails to fl ash momentarily the batteries are dead: Insert new batteries.
5. To close the batterie compartment, slide the battery compartment lid onto the battery
compartment from below to the point that it will click shut.