Back:
BACK PANEL
1.Power cord
The power cord connects hear. Only ~220-240V 50/60Hz voltage is acceptable.
2.Power amplifier output XLR-type connectors
SPEAKON output connectors are provided for the power amplifier channels 1 and 2.
3.Power amplifier output connectors
By using the vertically aligned connector for the power amplifier channels 1 and 2.Connecting
your speakers when your amplifier is in the bridge mode. In this way only one speaker is con-
nected.
4.Mode selection (1/2/3/4)
Pull dynamic code "1 / 4" switch "CH1/CH2 LF ON" position, in order to allow the letter below
100Hz frequency No. passed.
Pull dynamic code "2" switch "BRIDGE ON" position, for the bridge mode, input signal from the
channel to "1" Input, the volume from the channel "CH 1" potentiometer control input signal from
the channel "2" input, the volume from the channel "CH 2" potentiometer control.
Pull dynamic code "3" switch "PARALLEL ON" position, for the stereo mode, two channels ind-
ependently.
5.Power amplifier input connectors
The input sensitivity is set to 0dB by the factory. The inputs are electronically balanced.
( PAGE 4 )
1
2
4
5
5
3
CH1
(BRIDGE IN)
INPUTS
TRS TIP
TRS TIP
XLR PIN2
XLR PIN2
CH2
OUTPUTS
BRIDGE
CH2:1+1-
PIN OUT
B
R
ID
G
E
O
N
P
A
R
A
L
L
E
L
O
N
S
T
E
R
E
O
C
H
1
L
F
O
N
C
H
2
L
F
O
N
C
H
1
L
F
C
U
T
C
H
2
L
F
C
U
T
CH2
CH1
PIN OUT
CH1:1+1-
CH2:2+2-
BRIDGE:1+2-
ON
1 2 3 4
