5
. W I R I N G I N T R O D U C T I O N
DC power cable
Will meet the requirements of the nominal power is connected to the "Power Interface"
terminal, pay attention to the polarity; kind of connection wires, use 4-10AWG models.
Input connector is active power balance, pins 1 grounding (block), pin 2 cold (anode, -) Pins 3 hot
(positive, +)
Note: it is recommended to use symmetry (balance) shielded cable, because the balance of signal
noise and radio interference of AC power source is not so sensitive.
And unbalanced lines can cause noise, especially when long cable through.
2
Connected directly with the constant voltage speaker; Speaker output line should be 1 mm RVS
pair twisted copper wire. The diameter should be increased when the distance is longer.
The output line
1 channel maximum support power 500W, input current is 500W/24V = 20.83A, choose 10AWG wire.
2 channel maximum support power 1000W, input current is 1000W/24V = 41.67A, choose 7AWG wire.
4 channel maximum support power 2000W, input current is 2000W/24V = 83.83A, choose 4AWG wire.
Input line connection
10
