background image

Please visit www.itc-us.com for warranty info

3030 Corporate Grove Dr. • Hudsonville • MI • 49426

Phone: 616-396-1355 • www.itc-us.com • [email protected] •  DOC#: 710-00157 •  Rev B: 02.13.20

Connect Power supply cord to power supply using connectors 

provided

2.

Connect the low voltage harness to the power supply using 

the connectors provided

3.

Pre-layout lights to plan out your installation.  Considerations should be taken for wire routing,  mounting clip locations and mount-

ing, distance to the plants, etc. Identify a location to mount the power supply. Test fit wire leads between the power supply and the 

lights to ensure there is enough length of wire.  Wire routing should avoid moving parts, pinch points or sharp edges.  Note:  For 32 foot 

booms, we recommend placing a T-connector on the DC output of the power supply and then splice into the middle of the series of 

lights for even light distribution across the width of the series of lights. See wiring diagrams below. 

1.

Install the power supply to the mounting location using 

screws through the provided flanges on the power supply. 

5.

Begin to attach the lights to the mounting locations using 

the supplied clips.  4 clips should be used on each light and 

evenly spaced out.  Clips are designed to use zip ties or #8 

screws for mounting.  If using zip ties, we highly recommend 

using UV stable materials. Lights are installed into the clips by 

toeing one end in and pressing down on the light. 

6A.

22 FT Boom  

3 Light System Layout

32 FT Boom  

5 Light System Layout

Reviews: