For warranty information please visit www.itc-manufacturersselect.com/warranty
ITC Incorporated • 3030 Corporate Grove Dr. • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • Doc #: MSBTR1834 • Revision A: 05.19.20
Battery Powered Table System Install Instructions
(Base Part #: BTR1834 )
Mount the floor base into solid floor structure (wood,
fiberglass, etc.) using #12 phillips oval head screws
included with your table. Make sure screws are
appropriate for your substrate and that the substrate is
strong enough to support for the table.
1.
INSTALLATION CONSIDERATIONS
• To avoid a hazard to children, account for all parts and destroy all packing materials.
•
Do not sit on or lean on table, intended for use as a table only. Maximum load is 50 lbs distributed evenly.
•
The stiffness and rigidity of the floor mounting substrate has a direct effect on the sturdiness of the entire table system.
•
Recommended cleaning solutions: soap and water, Fantastic, Windex, 409 or Simple Green.
• Do not charge battery in wet or damp locations.
• Only charge the battery with the provided 12V charger. Use of any other charger may damage the battery.
• Remove battery before storage of table. Battery and charger should be stored in a dry location at room temperature (41◦F - 104◦F). Do not allow battery to freeze.
• For more information about the battery pack’s safety rules, please refer to the battery user’s manual.
Installing the Leg
Align the T-bolt on the bottom of the leg with the rectangular opening
in the floor base. Insert the T-bolt and begin to turn clockwise. After
one turn, pull up on the leg to ensure that the T-bolt is secure in the
floor base. Continue to turn the leg until the leg is secure.
2.
Removing The Leg & Table
1
To remove the table, press the button at the top of the post. *Twist top until it releases from taper fit then lift until it pops off the post.
2
To remove the leg, slide base release tab, then turn the leg counter-clockwise and lift gently until the leg removes from the base
3
Place
cover on floor base when the leg is not in place.
PARTS/TOOLS NEEDED:
Table & Table Base
(Table base comes attached to table)
Table Leg & Floor Base
Screws
Power Drill
(Not Provided)
Battery Pack &
Charger
Ensure the T-bolt is 3/8”
away from the bottom of
the leg
1.
3.
2.
3.
