Step 1:
Place the iTaste 134 MX-Z on a flat surface. Carefully unscrew the iTaste 134 MX-Z
1
st
top ring. This will expose the top of the 2
nd
ring. The 2
nd
silver ring has the 12
Zodiac Symbols printed on top with arrows pointing toward the inner pin.
Step 2:
Very carefully lift the 2
nd
silver ring up from the center pin. This will expose a 3
rd
black ring with Zodiac signs around the outside and a golden spring with two ball
bearings on top. Do not lose these pieces.
Very carefully lift the black internal ring. The ball bearings can easily jump out, roll
away and disappear so please do this carefully. There is a white plastic ring with a
small golden screw. If necessary use the provided screw driver to lift the white
plastic ring and unscrew the small golden screw. Replace the small golden screw
and the white plastic ring. Carefully place the 3rd Black ring on top.
Step 3:
If necessary replace the Golden Spring with the new replacement Golden Spring.
Carefully dispose of the old Golden Spring.
Choose your selected Zodiac Symbol. Take the 2
nd
ring and place it back over the center
pin. Line your selected Zodiac sign and arrow to point at the selection point at the base
of the center pin.
Step 4:
Push the 2
nd
ring down very firmly and hold it. You will be able to see the arrow pointing
to the selection point. Hold the 2
nd
ring down firmly and screw the 1
st
top ring back onto
the center post while holding the 2
nd
ring down and in place.
Firmly tighten the 1
st
top ring until it is firmly in place.
Technical Specifications:
Battery:
The iTaste 134 MX-Z uses IMR high-drain unprotected 18650 batteries.
Battery Length:
64.40—66.20, 3.7V.
The iTaste 134 MX-Z cannot use 2 stacked batteries.
Output Voltage is directly correlated to Battery voltage.
EN-12
EN-13
