S 2000/2001GM/3001GM EL7
6
6.1. LABEL FORMAT SET UP PROCEDURE
(see pictures 7 and 8)
The printer retains the label length and the backing
paper transparency in permanent memory. If changing
label format or print media type you have to use the
following procedure to update the values:
1 - Switch the printer off.
2 - Lift the printing head up by rotating lever #25b.
3 - Thread the web between the feed roller and the
printig head #21,105.
4 - Check web has been rightly positioned under the
label photosensor #10.
5 - Lift the printing head down by rotating the
lever #25a.
6 - Switch the printer on while pushing the print
(enter) button.
7 - Printer ejects some labels (depending on their
length) and stores the values of the media.
8 - Release the print button.
9 - The green led lit and the printer is ready to
work.
For further information about media options see chapter 7 and the paragraph "Labels, tags and
continuous media printing" of the
PROGRAMMING MANUAL
.
7. PRINTING MEDIA DESCRIPTION
7.1 PAPER SPECIFICATIONS
White coated glossy printing paper
- weight:
65 ÷ 90 g/mq (ISO536)
- caliper:
0,075 ÷ 0,083 mm (ISO534)
ADHESIVE SPECIFICATIONS
- peel adhesion(90° C): 430 N/m
- service temperature: -20° C ÷ + 70° C
LINER SPECIFICATIONS
- BG 40 brown, supercalendered glassine
- weight:
65g/mq (ISO536)
- caliper:
0.057 mm (ISO534)
- transparency:
45%
TAGS AND CONTINUOUS STRIPS
- weight:
200 g/mq max
SUGGESTED MODELS
- Fasson Fasthermal NT
- Kanzaki KPT 86-H
- Fasson Fastransfer MP - S470
- Fasson Fastransfer Extra - S470
LABEL AND TAGS DIMENSIONS
See Chapter 2
7.2. THERMAL RIBBON
SPECIFICATIONS
- film thickness 4.5 ÷ 6 micron
- core diameter: 25.4 mm
- outer diameter:
58 mm max
- width:
35 mm min/ 110 mm max
- length:
about 220 meters (58 mm DIA. max)
- ink coating outside
SUGGESTED MODELS
- TOIKO C 250 (matt paper)
- TOIKO CR 150 (glossy paper and polypropylene)
- TOIKO R 300 (plastic media)
STORAGE
Keep labels and ribbons in a dry place at temperature
not over 40° C and not exposed to direct sun light.
8. THERMAL RIBBON AND LABEL ROLL REPLACEMENT
8.1. THERMAL RIBBON REPLACEMENT
(see picture 7)
Open side of printer.
Remove the used roll. Remove the core #47 from the
shaft and put it on the rewinder #29.
By rotating the lever #25b, lift the printing head #105
from the feed roller #21, setting the movement of
the ribbon free.
Slide new ribbon #43 onto shaft and thread it under
the ribbon photosensor #48 and the threaders
#108,107 and 37 and up round to the rewinder #29.
Attach the ribbon leader with label/tape to core #47.
Return head lever to closed position #25a.
Close side of printer.
