ITALMOTO Tiquattro 125, Owner'S Manual

Page: 29 / 44

●
Battery
Battery is located under the seat. This vehicle battery is
electrolyte maintain-free type. During the first time use, please
ask your
dealer to add electrolyte, in future it doesn’t need to
add anymore. To take out battery follow
these steps:
a
、
Turn off motorcycle.
b
、
Take off seat.
c
、
Take off screw and battery plate.
d
、
First disconnect negative pole
(-)
and disconnect positive pole
(+)
.
e
、
Take out battery carefully. Put the battery back in opposite
sequence.
Caution:
When installing the battery, you must connect cable correctly.
If you do it wrong, it will damage battery and wire harness.
The red cable must connect to positive pole
(+)
,and black pole
connect to negative pole
(-)
. When you check or change the
battery make sue the motorcycle is off.
First time use, follow these steps:
Take off the seal paper on the top of battery, and add special
electrolyte into battery and close the cover; wait for 30
minutes.
After adding the electrolyte into new battery, charging battery
will increase durability.
In order to add the electrolyte, please follow the steps:
a
、
Put the battery on the flat ground, and take off the seal
paper
.
b
、
Take out the container which contains the electrolyte, and
remove battery cover stripe as plug. Caution: do not break the
stripe, it will be used as cover for battery.
c
、
Put the electrolyte into the 6 holes and fill in.
Caution
You must put battery in the flat ground, otherwise electrolyte
can not fill in completely.
d
、
Check the left and right side, it must have bubble
coming out from side pillar and wait for at least 20 minutes.
23