5
room in which they are installed.
11. During installation provision must be made for combustion air supply to the
appliance, which enters the appliance through the base and rear of the appliance, this
should not be blocked at any time. SEE TECHNICAL
V.
Operating Instruction:
FOR FITTING INSTRUCTIONS SEE INSTALLATION SECTION.
ALL GRIDDLES ARE FITTED WITH FLAME FAILURE DEVICE FOR SAFETY AND SPARK IGNITION
FOR EASE OF LIGHTING TO LIGHT BURNER:
1.
Use your left hand to push in the tap and turn it anti-clockwise to position”
”.
2.
Holding the tap fully in, use your right hand to depress the red ignitor button on the right
side and observe that the pilot lights. If it does not, repeatedly depress the ignitor button
until it does.
3.
When the burner is lit, continue to hold the tap in for about 15 to 20 seconds, then release
it.
4.
If it still couldn’t ignite after one minutes, then turn the tap back to position ”●”. Wait for
5 minutes, then repeat from step 1~3.
5.
When you use this appliance at the first time, there will be air inside the air inlet pipe,
which may result in the failure in ignition. Ignite again in the above-mentioned way until
it is successful.
6.
The fire is the most power when the switch of the appliance is turn to 90. When it is
turned to greater or less than 90, the fire will gradually reduce.
7.
When the heating plate is heated to the require temperature, you can begin to griddle
food, When the food is done, take out the food lest the surface of the hot plate will be
scratched.
8.
After use, turn the switch of the appliance clockwise until a ticking sound is heard and
turn off the control valve of the liquid gas storage tank.
Summary of Contents for GRN012
Page 4: ...6 EXPLODE...