Mechanical information
BGA292 Adaptation
BGA Adaptation: The Target can have electronic components placed around the
Microcontroller within the Emulation Adapter (EA) "ground floor", which impede
connecting the EA to the Target. In such cases the distance of the EA from the Target
can be optionally increased in steps of 3.25 mm by inserting the optional Extender. Not
more than two Extenders should be used since every connector affects signal integrity.
·
With no Extender the lowest point of the EA is approx. 4.35 mm away from the
Target.
·
With one Extender the lowest point of the EA is approx. 7.6 mm away from the
Target.
·
With two Extenders the lowest point of the EA is approx. 10.85 mm away from the
Target.
Note that by adding the Extender or two, makes the whole setup less robust. Use
caution with Extenders to prevent breaking of the hardware setup or just part of it.
Side view of the Emulation Adapter, one Extender and
Solder part (each Extender adds approx. 3,25mm)
Top view of the Solder part / Extender
Emulation Adapter
Unit (mm)
M
N
IEA-TC397XE Compact
29.1
22.4
BGA Assembly
Watch out that pin 1 position and alignment of all pins match when connecting two parts
together.
1. Mount the Solder part on the embedded target PCB.
2. If optional Extender is used, connect it to the Solder part. The Extender can also provide a
protection from damaging the Solder part if the Emulation Adapter setup is supposed to be
assembled and disassembled during the usage. In such case, it is recommended that the
Emulation Adapter is disconnected from the Extender and not from the Solder part. If the
Emulation Adapter setup needs to be disassembled, be cautious and gentle during this
