iSymphony M26, User Manual

Page: 9 / 29

–Problem
• Solution
No sound /power
–Volume not adjusted
• Adjust the VOLUME
–Power cord not securely connected
• Connect the AC power cord properly
–Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Display does not function properly /
No reaction to operation of any of
the controls
–Electrostatic discharge
• Switch off and unplug the set. Reconnect
after a few seconds
No disc indication
–No CD inserted
• Insert a CD, CD-R or CD-RW
–CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–Laser lens steamed up
• Wait until lens has cleared
–CD-R is blank or the disc is not finalized
• Use a finalized CD-R
CD playback does not work
–CD badly scratched/ dirty
• Replace/ clean CD (see maintenance)
–Laser lens steamed up
• Wait until lens has adjusted to room
temperature
The CD skips tracks
–CD damaged or dirty
• Replace or clean CD
–Program is active
• Quit Program mode(s)
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service
center.
WARNING:
Under no circumstances should you try to repair the set yourself, as this
will invalidate the warranty.
TROUBLESHOOTING SPECIFICATION
11 12
Specifications :
Power supply
Power consumption
Dimensions of unit
Frequency range
Antenna
CD Section
CD Size
Speaker System
Phones Jack
: AC 230 V, 50 Hz
: 17 Watts
: 446(W) X 228 (H) X 196 (D) mm.
: AM 540 - 1600 KHz.
: FM 88 - 108 MHz.
: FM - PIG TAIL ANTENNA.
: AM - FERRITE BAR ANTENNA.
: TOP LOADING CD PLAYER.
: 5” & 3” COMPATIBLE.
: 3 WAY 2 SPEAKERS SYSTEM
: 3.5 mm.