Isuzu C-240PW-28, Technical Manual, Page: 27 / 235

ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
CHAPTER 3
MAINTENANCE
Section I. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
3-1. PMCS PROCEDURES.
3-1.1. General.
To ensure that engine is ready for operation at all times, it must be inspected so defects can be discovered
and corrected before they result in serious damage or failure.
Perform operator’s PMCS prior to or in
conjunction with performance of engine PMCS. For engine PMCS, refer to TABLE 3-1.
Table 3-1. Preventive Maintenance Checks and Services (PMCS)
Item
Interval
Procedures Check Equipment is
No.
Item for and have Not/Ready
M Q S A B H
to be repaired or adjusted
Available
Inspected
as necessary If:
1 300 Oil Filter Change oil filter.
Refer to paragraph
3-14.1.
NOTE
Oil filter change inter
val is a hard time
replacement to be
used when AOAP
lab is not available.
2 750 PCV System Service PCV system.
Refer to paragraph
3-20.
3
1500 Cylinder Head Torque cylinder head
Bolts bolts. Refer to
paragraph 3-27.6d.
4 3000 Engine Valve
Clearances
NOTE
Valve clearance
must be checked
after cylinder head
bolt tightening has
been done. Refer to
step 3 in this table.
Adjust engine valve
clearances. Refer to
paragraph 3-26.6.
C h a n g e 2 3 - 1