Isuzu 1999 RODEO, General Description Manual

Page: 42 / 57

5A–42
BRAKE CONTROL SYSTEM
Chart B-5 Excessive Isolation Time (DTC 18 (Flash out) / C0274 (Serial communications))
Step
Action
Yes No
1 Check for anything causing extended ABS activation, such as
locked brakes or an erratic speed sensor signal.
Was a problem found?
Repair or
Replace Go to Step 2
2 1. The key turned off.
2. Replace EHCU.
3. Reconnect all components, ensure all components are
properly mounted.
Was this step finished?
Repeat the “Basic
diagnostic flow
chart” Go to Step 2
Chart B-6 G-Sensor Output Failure (DTC 21 (Flash out) / C0276 (Serial communications))
Step
Action
Yes No
1 1. Turn the key off.
2. Replace EHCU.
3. Reconnect all components, ensure all components are
properly mounted.
Was this step finished?
Repeat the “Basic
diagnostic flow
chart” Go to Step 1
Chart B-7 Brake Switch Failure (DTC 22 (Flash out) / C0281 (Serial communications))
Step
Action
Yes No
1 Is the stop light actuated when the brake pedal is depressed? Go to Step 2 Go to Step 4
2 1. Turn the key off.
2. Disconnected coil integrated module connector.
Is the check voltage coil integrated module connector (C-4)
terminals 13 to 7 when brake pedal is depressed than battery
voltage?
Go to Step 3
Harness between
brake SW and
coil integrated
module is faulty.
Go to Step 6
3 Is the check that pins C-5 connector 2, and C-4 connector 7 have
good ground? Check harness /
connector for
disconnection
Fault found:
Repair, and
perform system
self-check.
No fault found:
replace EHCU.
Go to Step 6
Repair.
Go to Step 6
4 Is stop light fuse normal?
Go to Step 5
Replace.
Go to Step 6
5 Is brake SW normal? Abnormal
harness in stop
light circuit.
Repair the
harness.
Go to Step 6
Replace.
Go to Step 6
6 1. Reconnect all components, ensure all components are
properly mounted.
2. Clear diagnostic trouble code.
Was this step finished?
Repeat the “Basic
diagnostic flow
chart” Go to Step 6