paint
International
Surface
Technologies
i s t s u r f a c e . c o m
L
eader
in
spray
booths
paint
International
Surface
Technologies
i s t s u r f a c e . c o m
L
eader
in
spray
booths
4
Spray gun cleaner Type GWMA 500
3.
Locate the drain valve
lever under the machine
and turn lever to vertical
position
[2]
1.
fill a 5 gal drum
with clean solvent or
water, for waterborne
cleaning, add 1 x 3.4 oz
bottle of water-based
cleaner in the drum
2.
transfer 1.3 gal of
cleaning fluid from the
drum into the 1.3 gal
container
[1]
In order to use the clean rinse feature, you will need one 5 gal drum and one 1.3 gal empty container.
WARNING
DO NOT SMOKE OR USE OPEN FLAME NEAR CABINET.
insTAllATion of conTAiners
2
1
5 gal
1.3 gal
WATER
Suction
filter
crocodile clamp
drain hose
Drain
hose
¼’’nylon
tube
4
3
SOLVENT
Drain valve
ground
4.
insert hose with suction filter into the 5 gal drum and enter drain tube
[3-4].
5. push the 5 gal drum under machine aligning filler neck with bottom part of flexible hose
[3-4].
6. place the full 1.3 gal container under the centre of the machine next to the 5 gal drum and insert the black ¼’’
nylon tube
[3-4].
7. for solvent-based cleaning, installation of ground wire is required. connect ground wires equipped with
crocodile clamp located inside the machine to any metal solvent containers if used. the machine must also
be grounded on a metal structure using the green ground wire located at the back as shown on the picture
below
[3].