3
Installation guide
Local Control Network - building controls in perfection
The LCN module can trigger a key additionally - it sends the
“HIT”
command. Up to 16
transponder cards can be assigned to an individual key. To do this, the input window
<
TRANSPONDER
> in the LCN-PRO must be opened and the serial number of the card with
the corresponding key (e.g. D3) registered. The serial number is a 6 figure combination
of letters and numerals. This can be determined on the Bus window beforehand.
To recognise non authorised cards, a serial number with 00 00 00 can be registered on
position 16. The LCN module then always sends out the assigned key, when it recogni-
ses a non assigned serial number. .
Note about function:
To parameterize the transponder, the LCN-PRO is needed and modules with firmware
0E.... (year 2005) or after. After the module firmware 10.... (year 2006 or later), the LCN-
UT has to be unlocked in the module properties.
Transponder cards:
For testing the functions, two different transponders are included in the delivery. The
card (illustr., page 4) achieves the largest range. Due to the fact that the LCN-UT
uses a standard protocol, the receiver reacts to many other sytems. Additionally
JUNGHANS offers wrist watches with built in transponders.
LCN-UT
®
