Isotra VERRA, Measurement And Assembly Manual

Page: 4 / 11

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 6. 2017
4
•
To the assembled brackets on the side without the control mechanism, insert the tube pin of the roller blind (for Verra
with marking plastic, for Verra Metal with marking metal).
•
Insert the tube with the fabric aside without the control mechanism on the inserted pin, and then insert the side with
control mechanism into the bracket before we hear the click (be careful about the metal / plastic orientation).
•
Fit the bracket caps depending on the roller blind type (Verra
– plastic cap, Verra Metal – metal cap).
•
Set the lower end position using the second chain joint.
•
Check the roller blind function and the brake operation.
ASSEMBLY WITH THE MOUNTING PROFILE:
For the Verra and Verra Metal roller blinds with the mounting profile, the roller blind is delivered in assembled condition
from the producer. During the actual assembly, it is only necessary to place mounting clips (into which the roller blind itself
clicks) on the wall or ceiling, at the proper distance, into which the roller blind itself clicks. After that, i tis only left to check
the lower end position and the total functionality of the roller blind.
ATTENTION!
FOR VERRA METAL ROLLER BLIND WITH FABRIC DAY/NIGHT THE ROLLER BLIND IS PROVIDED WITH THE
MOUNTING PROFILE WITH THE MOUNTING CLIPS.
NUMBER OF THE CLIPS:
Roller blind width (mm) Clips number (pc)
0
– 900
2
900
– 1600
3
1600 - 2200 4
The first clip must be always placed at a distance 40
– 50 mm from the edge of the roller blind.