Isotra VERANDA HRV80-ZIP, Measurement And Assembly Manual

Page: 5 / 30

MEASUREMENT AND ASSEMBLY MANUAL
Document validity: 23.5.2019
.05.2019
5
SAFETY ELEMENTS
Automatic controller: wind protection.
Automatic controller: wind/sun control system.
Read the operation manual carefully.
Note: The user must always be aware whether the screen is open, or closed. The automatic controller may malfunction
in abnormal conditions like power failure, defect, sudden storm, etc., and this may lead to the awning damage and risk
of falling.
If you are aware of your absence for a longer period of time, switch the automatic controller to manual control and roll
up the awning before leaving.
If the lower section moves at a height less than 2.5 metres above the ground level, the awning must be controlled by a
pulse switch (if you release the switch, the motor stops). This will ensure the user has always a good view of the moving
awning and injury to persons is prevented.
The motor-operated awning cannot be rolled up after power failure. In areas with high wind force levels and frequent
power failure, it is recommended to use a special motor-generator assembly as an emergency power unit.
REPAIRS, MAINTENANCE, AND DEFECTS
Regular inspections and maintenance (at least once a year) is recommended for optimal use of the awning. To ensure
your personal safety, we recommend concluding a maintenance contract with an awning installation company –
preferably with the person who installed your awning.
The awning requires regular inspections for wear and damage to the fabric and frame. It is forbidden to use damaged
awnings.
In the event of failure, contact the maintenance company. If regular, annual maintenance using original spare parts is
not carried out by a specialised company, any and all guarantee claims will be rendered void.
MAINTENANCE AND REPAIRS OF THE SUN SCREEN, ESPECIALLY OF ITS FOLDING ARMS, MOTORS,
AND SAFETY ELEMENTS, MAY ONLY BE CARRIED OUT BY AUTHORISED PERSONS. MOTORS MAY
SWITCH ON UNEXPECTEDLY. IT IS THEREFORE NECESSARY TO DISCONNECT THE MOTORS FROM
THE MAINS (E.G. BY SWITCHING OFF THE CIRCUIT BREAKER) WHILE CLEANING OR MAINTENANCE
IS CARRIED OUT.
OUR PRODUCTS MUST BE INSTALLED IN A MANNER THAT ENSURES ALL PARTS ARE ALWAYS
ACCESSIBLE FOR MAINTENANCE AND REPAIRS. THE MANUFACTURER SHALL NOT BEAR ANY
ADDITIONAL COSTS (E.G. FOR DEMOLITION WORKS, REPAIRS OF THE FACADE AND INTERIOR
WALLS) CAUSED BY FAILURE TO COMPLY WITH THIS REQUIREMENT.
The following simple maintenance and inspection works can be carried out by the users:
Maintenance of the mechanic parts:

Check of damage and/or wear of pull cords (once in 3 months).

Check of position of the cords in the pulleys (once in 3 months).

Regular cleaning of areas in the guiding sections where the sliding block castors move (once in 3 months, or
more frequently, if required).

Lubrication of the sliding block castors (at least once a year).