Isotherm 3160BB1C, Instruction Manual

Page: 13 / 24

Manuale d’uso – User’s Manual
CG 23072012 Ver 1.2 Pag.
13
Installation
Almost all boats have a specific space for the
installation of the refrigerator. Isotherm fridge /
freezer is designed to meet the normal size of
installation.
The compressor must stay in upright position but
will work even with a 30 degrees swing and more
for short periods.
The minimum requirements for installation on
board are:
• 2 cm light above the unit (between the fridge
and line of furniture);
• Laterally, the walls of the refrigerator can be put
in contact with the furniture, except the spaces of
vents where 90 mm openings shall be made (see
figures below)
Make nr. 2 holes opposite 90mm with safety grid
in correspondence with the air vents and make
sure the environment beyond the holes is open
and well ventilated
If the environment in correspondence with the
holes is not free and well ventilated you should
use a flexible hose to funnel air (optional) both on
device’s entry and exit, from and to open
environments with the possibility of air circulation.
In these environments, any apparatus/equipment
which can increase air temperature must be
present.
The air intake is on the left side of the apparatus
and it is recommended that air comes from an air
conditioned environment. See fig. below.
Frontal View
Recommended Installation
In order to maximize performance and efficiency
of the product (optimal functioning and reduced
power consumption), we suggest adding at the
minimum requirement of 2cm light at the top,
further 2cm light on each side.
Fixing
For mounting the unit, use self-tapping screws
with diameter 3.2 mm, 16mm length. The device
should be fixed by a mounting flange bearing
holes (see figure below).
Make sure that the material, where the unit is
fixed, is solid and robust. After mounting check
that the device is stable and immobile.