12-
3.3 Home Position Adjust
In the main functions, hold
Enter
button for at least 3 seconds into offset mode, use
DOWN
and
UP
button up to chose
,
,
or
, Pressing
ENTER
button and
the display will blink. Use
DOWN
and
UP
button to adjust the home position of the Pan, Tilt,
Color, Gobo. Once the position has been selected, press the
ENTER
button to setup, Hold
and press the
MENU
button about one second or wait for one minute to exit the menu mode.
4. How To Control The Unit
You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Easy controller
3. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effect at once. Every time you turn the unit on, it will show
on the
display and move all the motors to their ‘home’ position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built in
programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
and select
(show 1) or
(show 2) or
(show 3) or
(show 4) mode. Its
DMX input jack will have nothing plugged into it, and Its master LED will be constantly on
and sound LED will flash to the music. The other units will have to set in slave mode
and select
(normal) or
(2 light show) mode, Their DMX cables plugged into
the DMX input jacks (daisy chain) and the slave led lights will constantly on.
13-
2-light show
In
(slave mode),
means the unit works normally and
means
2-light show. In order to create a great light show, you can set
on the second unit to
get contrast movement to each other, even if you have two units only.
4.2 Easy Controller (By CA-8/CA-9 RTX)
The easy remote control is used only in master/slave mode. By connecting to the 1/4”
microphone jack (For CA-8) or 5-pin socket (For CA-9RTX) of the first unit, you will find that
the remote controller on the first unit will control all the other units in Stand by, and Mode
selection.
Stand By
Blackout the unit
Function
1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Show
1-4
1. Press to select color
2. Hold to select gobo
Mode
Sound (LED OFF)
Show
(LED Slow Blinking)
LED ON
4.3 DMX Controller
By using a universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press and keep
ENTER
button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the
MENU
button again. If you use please refer to the
following diagram to address your DMX512 channel for the first 4 units
：
