8-
MENU
To select the programming functions
DOWN
To go backward in the selected functions
UP
To go forward in the selected functions
ENTER
To confirm the selected functions
Remote controller input
By connecting to the 1/4” microphone jack to control the unit for Stand by, Function, and
Mode function.
Sensitivity
To adjust the sound-receiving sensitivity .
Microphone
To receive audio signal for sound activation .
DMX input/output
For DMX512 link, use 3-pin XLR plug cable to link the unit together.
9-
4.2. Main Function
To select any of the pre-set functions, press the
MENU
button up to when the required one
is shown on the display. Select the function by
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the mode. Once the required mode has been selected,
press the
ENTER
button to setup or it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press the
MENU
button. The main functions are shown below:
MENU
Self-Test
Reset
Fixture Hours
Display Inversion
Display Normal
Tilt Inversion
Tilt Normal
Pan Inversion
Pan Normal
Slave mode " 2 Light Show "
Slave Mode " Normal "
DMX512 Address Setting
Blackout Mode " No Blackout "
Blackout Mode " Yes Blackout "
LED on
LED off
Setting 16 Channel
Setting 8 Channel
Show mode 2
Show mode 1
Show mode 3
Show mode 4
Ambient temperature of lamp
Lamp off
Lamp on
DMX512 Address Setting
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press the
ENTER
button to setup or automatically
return to the main functions without any change after 8 seconds. To go back to the functions
without any change press the
MENU
button again.
