Attach the Swivel Nut to one end of the Lead Line (this is where hose will attach).Then run the Lead Line
along the umbrella pole up to one of the umbrella ribs and use the Cable Tie to clamp the tubing onto
umbrella pole and rib (same for option A or B). NOTE: If you are inserting your umbrella in a patio table
that has a hole only big enough for umbrella pole, do NOT run the line down the pole through the hole. This
can damage the Lead Line or restrict water flow. Attach the Elbow Fitting to line at the end of the rib.
Starting at the rib end where you have positioned the Elbow Fitting, insert a Misting Line into Elbow
Fitting, feed the line through a center loop and attach a Tee-Fitting to other end. At each rib end there will
be a Tee-Fitting with elastic loop on either side of it. Continue in this order until you have inserted the
misting line completely around the perimeter of the umbrella, through all the loops, until you’re back at
the Elbow Fitting. Cap the end of the misting line with End Fitting. NOTE: Stretch the tubes tight during
installation to prevent sagging. If the tubes do sag in places, you may want to add some Umbrella Clips.
Adjust Nozzles at 45 degree angle to the ground and away from the covered portion of the umbrella.
Option B (using umbrella clips)
Attach the Swivel Nut to one end of the Lead Line (this is where hose will attach).Then run the Lead Line
along the umbrella pole up to one of the umbrella ribs and use the Cable Tie to clamp the tubing onto
umbrella pole and rib (same for option A or B). NOTE: If you are inserting your umbrella in a patio table
that has a hole only big enough for umbrella pole, do NOT run the line down the pole through the hole. This
can damage the Lead Line or restrict water flow. Attach the Elbow Fitting to line at the end of the rib.
Secure the Elbow fitting on the umbrella rib end with the Hanger Clips provided. Clip the Misting Line
about 1-2 inches on the left and the right side of Tee with Nozzle fitting as shown.
