ISHIDA IP-AI, Operation Manual, Page: 5 / 139

V
• Be sure to install the printer unit and
the weighing unit on level ground.
Install the four rubber feet of the printer unit on
the mount.
Accurate weighing cannot be made if the
weighing unit is not horizontally installed.
If the printer unit or the weighing unit falls over, it
may result in injury.
• Always use the specifi ed voltage.
• Prepare a dedicated power source and always
use a power supply with rated voltage. Never
connect the machine power input with an AC
power supply exceeding the rated voltage.
• To avoid any potential electrical shock, ensure
that the protective ground wire is connected to
the main grounding provision.
• A power supply that generates voltage variation
may cause a malfunction, or using the machine
outside of the rated voltage may result in
machine failure or danger such as electric
shock.
• The equipment disconnect device is considered
to be: Plug, Appliance inlet.
• Replacement of fuses is limited only by service
personnel. Service personnel should refer to
service documentation for instructions for the
replacement.
• Replacement of Battery is limited only by
service personnel.
* To Service personnel:
Risk of Explosion if Battery is replaced by an
Incorrect Type. Dispose of Used Batteries
According to the Instructions.
• Ensure that the printer unit, display
unit and terminals do not come into
contact with water.
If water comes in contact with these units or
terminals, this may cause a fi re.
PRECAUTIONS FOR USE
For safe operation, the following safety considerations must be observed: