Iseo Zero1 Thesis 2.0 Standard, Instruction Manual

Page: 29 / 104

GB
1 -9
1.4 STRIKING PLATE ADJUSTMENTS
Adjust the “door positioning” sensor (1) to a
maximum distance of 5 mm from the front
of the lock. Distances greater than this will
compromise the correct functioning of the
lock in the automatic closing phase of the
bolt.
Adjust the protrusion of the door (2) ali-
gnment sphere working a screwdriver in a
clockwise or counter-clockwise direction.
Adjust the thrust force of the sphere (3) . To
this end, insert a small screwdriver into the
sphere’s opening until you reach the screw
placed on the brass cap. Turn counter-clockwi-
se to increase the pressure of the thrust, or in
a clockwise direction to diminish it.
NOTE
Be careful not to excessively turn the screw-
driver clockwise (3) , as you may run the risk
of unscrewing the rear cap, which holds the
spring in place, inserted in the group.
1
2/3
2
3